Panasonic Washing Machine Error Codes

Washing Machine is useful Product from Every home And it is a product used in every home Sometimes it contains an error code. We can fix some error codes at home and we need to call a technician to fix some error codes. In this post you will find all the error codes of Panasonic washing machine and I hope you will benefit a lot from this post. If you find it helpful, please share this post.

Error code	Problem
E01	Door is not locked or Door is unlocked during programme
E02	Lack of water
E03	Pump failure
E04	Overflow
E05	NTC or Heater Failure
E06	Motor Failure – 1 (Tachometer open-short circuit or motor connector is disconnected)
E08	Motor Failure – 2 (triac short circuit)
E10	Electronic Pressure Sensor
H01	Water level sensor error
H02	Motor triac error
H04	Load relay short error
H05	The memory circuit of IC error
H12	Safety switch connection error
H17	Thermistor error (for X series)
H21	Overflow error
U11	Water can not drain
U12	The lid is open
U13	Spin or Air Dry is not possible
U14	Water can not be supplied
U99	Water has been forcibly drained
U18	Pump or drain filter detected as being not secure.
H07	Tacho generator signal from motor irregular or out of range.
H09	Communication error between power and display electronic cards.
H18	Motor thermistor sensor detected abnormal signal or out of range. Check motor connections. Replace motor.
H23	Heater relay on main control PCB detected abnormal or out of range. Check electronic controller. Replace main power electronic card.
H25	Motor error detected. Check wiring to main motor. Replace motor. Replace power electronic card if problem persists.
H27	Door lock on the washing machine will not engage with latch in place.
H29	Cooling fan detected as running slow, abnormal, short or open circuit.
H41	During spoin data cannot be obtained from 3D sensor.
H43	Leak detected to base of the washing machine. Check for source of the leak.
H46	Abnormal signal from leak detector in base of the washing machine.
H51	Overloaded motor detected. The washing machine has detected that the main drive motor is under stress for some reason.
H52	Too high input voltage detected. Check mains electricity supply as this is caused by abnormal mains.
H53	Too low voltage input detected. Check mains electricity supply as this is caused by abnormal mains.
H55	Abnormal current detected while the main motor is rotating. Replace main drive motor.

No results